TSX L4-2.4L (2005)
Brake Caliper: Service and Repair
Removal and Installation
Rear Brake Pad Inspection and Replacement
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Replacement
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. Remove the rear wheels.
2. Remove the flange bolts (A) while holding the pin (B) with a wrench being careful not to damage the pin boot, and remove the caliper (C). Check
the hose and pin boots for damage and deterioration.
3. Remove the pad shim (A) and pads (B).
4. Remove the pad retainers (A).
5. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
6. Check the brake disc for damage cracks.
7. Clean and install the pad retainers.
