TSX L4-2.4L (2005)
3. Using a micrometer (A), measure brake disc thickness at eight points, approximately 45° apart and 10 mm (0.4 inch) in from the outer edge of the
disc. Replace the brake disc if the smallest measurement is less than the max. refinishing limit.
Brake disc thickness:
Standard: 27.9 - 28.1 mm (1.10 - 1.11 inch)
Max. refinishing limit: 26.0 mm (1.02 inch)
Brake disc parallelism: 0.015 mm (0.0006 inch) maximum
NOTE: This is the maximum. allowable difference between the thickness measurements.
4. If the smallest measurement is less than the max. refinishing limit, replace the brake disc.
5. If the brake disc is beyond the service limit for parallelism, refinish the disc with an on-car brake lathe. The Kwik-Lathe produced by Kwik-way
Manufacturing Co. and the "Front Brake Disc Lathe" offered by Snap-on Tools Co. are approved for this operation.