TSX L4-2.4L (2005)
Oil Filter: Service and Repair
Engine Oil Filter Replacement
Special Tools Required
^
Oil filter wrench 07HAA-PJ70100
1. Remove the oil filter with the special tool.
2. Inspect the threads (A) and the rubber seal (B) on the new filter. Clean the seat on the engine block, then apply a light coat of oil to the filter
rubber seal. Use only filters with a built-in bypass system.
3. Install the oil filter by hand.
4. After the rubber seal seats, tighten the oil filter clockwise with the special tool.
Tighten: 3/4 turn clockwise
Tightening torque: 12 Nm (1.2 kgf-m, 8.7 ft. lbs.)
