TSX L4-2.4L (2005)
5. If 4 numbers or marks (1 to 4 or V to VVVV) are printed around the outside of the filter, use the following procedure to tighten the filter.
^
Spin the filter on until its seal lightly seats against the block, and note which number or mark is at the bottom.
^
Tighten the filter by turning it clockwise 3 numbers or marks from the one you noted. For example, if number 2 is at the bottom when the seal
is seated, tighten the filter until the number 1 comes around the bottom.
6. After installation, fill the engine with oil up to the specified level, run the engine for more than 3 minutes, then check for oil leakage.
Oil Filter Feed Pipe Replacement
1. Remove the oil filter.
2. Remove the oil filter feed pipe.
3. Install the two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe. Hold the nut with a wrench, then tighten the other nut.
4. Tighten the oil filter feed pipe to the block to 49 Nm (5.0 kgf-m, 36 ft. lbs.), then remove the nuts from the oil filter feed pipe.