TSX L4-2.4L (2005)
5. Tighten the bolts in two or three steps. In the final step, tighten all bolts, in sequence, to 12 Nm (1.2 kgf-m, 8.7 ft. lbs.).
6. Install the stiffener.
7. Remove the special tool, then tighten the bolt securing the side engine mount bracket.
If the engine still in the vehicle, do the following steps
8. Install the upper bracket, then install the ground cable.
9. Install a new set ring on the end of left side driveshaft, then install the driveshaft. Make sure each ring "clicks" into place in the differential.
10. Connect the right side suspension lower arm ball joint.
11. Install the right side damper fork.
12. Connect the stabilizer links.
13. Install the splash shield.
14. Lower the hoist.
15. Tighten the front mount bolt, then install the front mount stop.
16. Tighten the rear mount bolt, then install the rear mount stop.
17. After assembly, wait at least 30 minutes before filling the engine with oil.
