TSX L4-2.4L (2005)
these parts:
During the repair process, inspect these areas:
-
Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
-
Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
After the vehicle is completely repaired, turn the ignition switch ON (II). If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is
OK. If the indicator does not function properly, use the HDS SRS Menu Method to read the DTC.
Checking and Adjusting the Headliner/Pillar Trim Overlap
To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less then 15
mm. To check the overlap, do this:
1. Install the headliner (A) and the pillar trims (B).
2. Using masking tape on the headliner, mark the upper edge of each pillar trim.
3. Remove the pillar trims, and measure the headliner overlap.
-
If the overlap is less than 15 mm, remove the tape, and install the pillar trims.
-
If the overlap is more than 15 mm, go to step 4.
