TSX L4-2.4L (2005)
4. Lean the retractor over 40 °, and make sure that the seat belt does not lock when pulled out over about 1,200 mm (47.24 in.). Do not attempt to
disassemble the retractor.
5. Replace the seat belt with a new assembly if there is any abnormality. Do not disassemble any part of the seat belt for any reason.
In-vehicle
1. Check that the seat belt is not twisted or caught on anything.
2. After installing the anchors, check for free movement on the anchor bolts. If necessary, remove the anchor bolts and check that the washers and
other parts are not damaged or improperly installed.
3. Check the seat belts for damage or discoloration. Clean with a shop towel if necessary. Use only soap and water to clean.
NOTE: Dirt buildup in the metal loops of the upper anchors can cause the seat belts to retract slowly. Wipe the inside of the loops with a clean
cloth dampened in isopropyl alcohol.
4. Check that the seat belt does not lock when pulled out slowly. The seat belt is designed to lock only during a sudden stop or impact.
5. Check the cancel function of the center seat belt retractor. You should be able to pull the length of the belt out of the retractor without it locking.
Then, each time you pull the belt as it retracts, the belt should lock.
NOTE: Make sure the left seat-back does not catch the center belt when you quickly fold the seat-back forward.
6. Make sure that the seat belt will retract automatically when released.
7. On the passenger's seat belt, check the ALR (automatic locking retractor) mechanism. This function is for securing child seats.
1. Pull the seat belt all the way out to engage the ALR. The seat belt should retract with a ratcheting sound, but not extend. This is normal.
2. To disengage the ALR, release the seat belt and allow it to fully retract, then pull the seat belt out part-way. The seat belt should retract and
extend normally.
8. Replace the seat belt with a new assembly if there is any abnormality. Do not disassemble any part of the seat belt for any reason.
