TSX L4-2.4L (2005)
Control Arm: Service and Repair
Lower Arm
Lower Arm Removal/Installation
Special Tools Required
Ball joint remover, 28 mm 07MAC-SL00200
1. Raise the front of the vehicle, and support it with safety stands in the proper locations.
2. Remove the front wheel.
3. Remove the damper fork (A) from the damper (B) and lower arm (C).
NOTE: During installation, insert the damper fork into the damper lower end so the aligning tab (D) is aligned with the slot (E) in the damper
fork. Replace the damper fork mounting nut (F) with a new one.
4. Remove the flange nut (A) while holding the joint pin (B) with a hex wrench (C), and disconnect the stabilizer link (D) from the lower arm (E).