TSX L4-2.4L (2005)
6. Install the upper arm in the reverse order of removal, and note these items:
^
Be careful not to damage the ball joint boot when connecting the upper arm to the knuckle.
^
Tighten all mounting hardware to specified torque values, except for the upper arm mounting bolts.
^
Tighten the castle nut to the lower torque value, then tighten it only far enough to align the slot with the hole in the stud. Do not align the castle
nut by loosening it.
^
Use a new cotter pin on the castle nut.
^
Before installing the wheel, clean the mating surface on the brake disc and the inside of the wheel.
^
Check the front wheel alignment, and adjusting it if necessary.
^
Insert a rod (A) of appropriate size (O.D.6 mm/L: 300 mm) into the positioning holes (B), and place the upper arm (C) on the rod to position it
before tightening the upper arm mounting bolts.
