TSX L4-2.4L (2005)
4. Check the front knuckle ring (A) for damage or deformation, and replace it if necessary.
5. Press the wheel bearing (A) out of the knuckle (B) using the special tool and a press.
6. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
7. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the special tool, and a press.
NOTE:
^
Install the wheel bearing with the wheel sensor magnetic encoder (E) (brown color), toward the inside of the knuckle.
^
Remove any oil, grease, dust, and other foreign material from the encoder surface.
^
Keep any magnetic tools away from the encoder surface.
^
Be careful not to damage the encoder surface when you insert the wheel bearing.
