ZDX V6-3.7L (2010)
Blind Spot Module: Service and Repair
BSI Radar Unit Removal/Installation
BSI Radar Unit Removal/Installation
1. Remove the rear bumper See: Body and Frame/Bumper/Rear Bumper/Service and Repair.
2. Disconnect the 6P connector (A), and detach the harness clips (B).
3. Remove the bolts and the BSI radar unit (C).
4. Clean the surface of the BSI radar unit.
5. Install the BSI radar unit (A) with the bolts.
6. Connect the 6P connector (B) and attach the harness clips (C).
7. Do the BSI radar unit aiming inspection See: Testing and Inspection/BSI Radar Unit Aiming Inspection.
