ZDX V6-3.7L (2010)
5. Install new screw grommets on the millimeter wave radar. Position the left side grommet grooves (E) horizontally, and position the right side
grommet groove (F) vertically.
6. Tighten the main bracket bolts a little at a time until the clearance between the millimeter wave radar and the main bracket is 16 mm (0.63 in) (G).
Make sure the millimeter wave radar is parallel with the main bracket.
7. Clean the surface of the millimeter wave radar.
8. Install the millimeter wave radar (A), then tighten the bolts in the numbered sequence shown.
9. Connect the 5P connector (B), and attach the harness clips (C) to the main bracket (D).
10. Install the front bumper See: Body and Frame/Bumper/Front Bumper/Service and Repair.
11. Aim the millimeter wave radar See: Adjustments.
