ZDX V6-3.7L (2010)
The normal warranty applies.
Failed Part:
P/N 91570-SZN-A11
Defect Code:
02502
Symptom Code:
06201
Skill Level:
Repair Technician
REPAIR PROCEDURE
1. Remove the damaged retainers or leftover adhesive from the body:
NOTE:
Avoid damaging the paint by applying heat gradually to the retainer.
^
Be careful not to scratch the body.
^
Avoid damaging plastic parts by removing them or covering them with aluminum foil.
^
Using a heat gun, heat the retainer or leftover adhesive to between 212°-248° (100°-120°).
^
Use a plastic scraper to loosen the retainer from the body and to scrape off any adhesive.
^
Use pliers to gently pull the retainer clip from the body.
2. Clean the bonding surface on the body with a shop towel dampened with 3M General Purpose Adhesive Cleaner or isopropyl alcohol. After cleaning,
keep oil, grease, and water from getting on the bonding surface.
3. Prepare the 3M Adhesive:
NOTE:
3M Scotch-Weld DP-100 NS Adhesive is supplied in a dual syringe plastic Duo-Pak cartridge as part of the 3M Scotch-Weld EPX Applicator
system.
^
Insert the Duo-Pak cartridge into the applicator.
^
Using light pressure on the trigger, start the plunger into the cartridges.
