ZDX V6-3.7L (2010)
Arm Rest: Service and Repair
Rear Seat Armrest Beverage Holder Replacement
Rear Seat Armrest Beverage Holder Replacement
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857
NOTE:
-
Take care not to tear or damage the seat covers.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Detach the clips from the armrest trim (A), then remove the beverage holder (B).
2. If necessary, release the hooks (A) from the wire (B), then remove the armrest trim (C).
3. Install the armrest beverage holder in the reverse order of removal, and make sure the hooks are installed securely to the wire, then push down on
the beverage holder.
