ZDX V6-3.7L (2010)
16. Remove airbag attachment wire B from the outside reinforcing cloth (C). Pull airbag attachment wire A out through loop (D) of the inside
reinforcing cloth (E). Remove airbag attachment wires A and B.
17. Install the cover in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
To prevent wrinkles when installing seat-back cover, make sure the material is stretched evenly over the pad before securing the clips, the
hooks, and the hook strips.
-
Before installing the seat-back cover, make sure airbag attachment wires A, B are installed in the reinforcing clothes (C) correctly.
-
Replace any clips (D) you removed with new ones.
-
Reinstall airbag attachment wires A, B securely to the seat-back frame as shown.
-
Use only original Acura replacement seat-back covers.
-
Make sure the side airbag harness and the seat wire harnesses are routed properly.
-
Push the clips and the hooks into place securely.