ZDX V6-3.7L (2010)
Seat Cover: Service and Repair
Rear Seat-Back Cover Replacement
Rear Seat-Back Cover Replacement
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
-
Trim Pad Remover Snap-on A 177A or equivalent, commercially available
*Available through the Acura Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to tear or damage the seat covers.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
The left seat-back is shown; the right seat-back is similar.
1. Remove the armrest See: Interior Moulding / Trim/Arm Rest/Service and Repair/Rear Seat Armrest Replacement.
2. Remove the seat-back See: Service and Repair/Rear Seat Removal/Installation.
3. Remove all of the head restraints.
4. Left seat-back: Remove the screws, then pull up the center belt guide (A) to release the hook (B) and remove it.
5. Pry up the cap (A), and remove the screw. Release the hooks (B), then remove the latch knob trim (C).