ZDX V6-3.7L (2010)
Seat Heater Switch: Service and Repair
Seat Heater Switch Test/Replacement
Front Seats
1. Remove the center console panel See: Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center Console Panel
Removal/Installation.
2. Remove the two screws, and the seat heater switch from the panel.
3. Check for continuity between the terminals in each switch position according to the table.
NOTE:
-
Make sure the correct test lead (+ or -) is placed on the terminal.
-
When check for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
-
Be careful of the diode's current flow direction (Diodes allow current to flow in one direction (forward), but not in the opposite direction
(reverse)).
4. If the continuity is not as specified, replace the switch.
Rear Seat
1. Remove the center console rear trim See: Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center Console Rear
Trim Removal/Installation.
