ZDX V6-3.7L (2010)
8. If the rocker arm assembly is disassembled, reassemble the rocker arm assembly See: Cylinder Head Assembly/Service and
Repair/Overhaul/Rocker Arm and Shaft Disassembly/Reassembly.
9. Remove all of the old liquid gasket from the rocker shaft holder and the cylinder head.
10. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the rocker shaft holder mating surface of the cylinder head.
Install the component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply a 2.5 mm (0.098 in) diameter bead of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
11. Set the rocker arm assembly in place, and loosely install the bolts. Make sure that the rocker arms are properly positioned on the valve stems.
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the rocker arm assembly.
12. Tighten each bolt two turns at a time in the sequence shown to ensure that the rockers do not bind on the valves.
13. Install the injector base (A). Always use a new gasket (B).
