ZDX V6-3.7L (2010)
NOTE:
-
Apply a 2.5 mm (0.098 in) diameter bead of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
29. Install the dowel pins (A), a new O-ring (B), and the engine block end cover (C) on the engine block.
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the engine block end cover.
30. Clean the excess grease off the crankshaft, and check that the oil seal lip is not distorted.
31. Install a new crankshaft oil seal in the oil pump See: Engine Lubrication/Oil Pump/Service and Repair.
32. Remove all of the old liquid gasket from the oil pump mating surfaces, the bolts, and the bolt holes.
33. Clean and dry the oil pump mating surfaces.
34. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the engine block mating surface of the oil pump and to the
inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply a 2.5 mm (0.098 in) diameter bead of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
