ZDX V6-3.7L (2010)
35. Apply a light coat of new engine oil to the lip of the crankshaft oil seal, and apply new engine oil to the new O-ring (A).
36. Install the dowel pins (B), then align the inner rotor with the crankshaft, and install the oil pump (C).
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the oil pump.
37. Clean the excess grease off the crankshaft, and check that the oil seal lip is not distorted.
38. Install the baffle plate (D), then install the oil strainer (E) with a new O-ring (F).
39. Install the rocker arm oil control solenoid/oil filter assembly (A), with a new rocker arm oil control solenoid filter (B).
