ZDX V6-3.7L (2010)
Harmonic Balancer - Crankshaft Pulley: Service and Repair
Crankshaft Pulley Removal and Installation
Special Tools Required
-
Holder Handle 07JAB-001020B
-
Holder Attachment, 50 mm, Offset 07MAB-PY3010A
-
Socket, 19 mm 07JAA-001020A or equivalent
Removal
1. Raise the vehicle on the lift.
2. Remove the right front wheel.
3. Remove the splash shield See: Body and Frame/Splash Guard/Service and Repair/Front Splash Shield Replacement and the engine undercover
See: Body and Frame/Splash Guard/Service and Repair/Engine Undercover Replacement.
4. Remove the drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair.
5. Hold the pulley with the handle, 6-25-660L (A) and the holder attachment, 50 mm, offset (B).
6. Remove the bolt with a heavy duty 19 mm socket (C) and a breaker bar, then remove the crankshaft pulley.
Installation
1. Remove any oil and clean the pulleys (A), the crankshaft (B), the bolt (C), and the washer (D). Lubricate with new engine oil as shown.
2. Install the crankshaft pulley, and tighten the bolt. Do not use an impact wrench.