ZDX V6-3.7L (2010)
1. Hold the pulley with the handle (A) and the holder attachment (B). Torque the bolt to 65 Nm (6.6 kg-m, 48 lb-ft) with a torque wrench and a
19 mm socket (C).
2. Mark the bolt head (D) and the crankshaft pulley (E) as shown, then tighten the bolt an additional 60 ° (The mark on the bolt head lines up
with the mark on the crankshaft pulley).
3. Install the drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair.
4. Install the splash shield See: Body and Frame/Splash Guard/Service and Repair/Front Splash Shield Replacement and the engine undercover See:
Body and Frame/Splash Guard/Service and Repair/Engine Undercover Replacement.
5. Install the right front wheel.