ZDX V6-3.7L (2010)
Air Door Actuator / Motor: Service and Repair
Passenger's Air Mix Control Motor Replacement
Passenger's Air Mix Control Motor Replacement
1. Remove the passenger's dashboard undercover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Passenger's Dashboard Undercover Removal/Installation.
2. Remove the glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove Box Removal/Installation.
3. Release the wire from its harness clip (A), then remove the self-tapping screws and the passenger's heater duct (B).
4. Disconnect the 5P connector (A) from the power transistor, and the 7P connector (B) from the passenger's air mix control motor (C). Remove the
self-tapping screws and the passenger's air mix control motor from the heater unit.
5. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make
sure the motor runs smoothly.