ZDX V6-3.7L (2010)
Air Door Actuator / Motor: Service and Repair
Passenger's Mode Control Motor Replacement
Passenger's Mode Control Motor Replacement
Removal
NOTE: Set the passenger's side climate control to the VENT position before removing the motor.
1. Remove the passenger's dashboard undercover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Passenger's Dashboard Undercover Removal/Installation.
2. Remove the glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove Box Removal/Installation.
3. Remove the glove box frame See: Blower Motor/Service and Repair/Blower Unit Removal/Installation.
4. Release the wire from its harness clip (A), then remove the self-tapping screws and the passenger's heater duct (B).
5. Disconnect the 7P connector (A) from the passenger's mode control motor (B). Release the wire from its harness clip (C), then remove the
self-tapping screws and the passenger's mode control motor from the heater unit.