ZDX V6-3.7L (2010)
-
For proper disposal of a damaged airbag, refer to airbag disposal See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Procedures
.
-
The side curtain airbag module assembly is a long, jointed part containing an inflator (A), a flexible bag (B), and brackets (C). When removing or
installing the side curtain airbag assembly, never:
-
Handle the flexible bag.
-
Drop the airbag assembly.
-
Cut, tear, or unwrap the tape strips.
SRS Unit, Front and Side Impact Sensors, Rear Safing Sensor, Driver's Seat Position Sensor, and Front Passenger's Weight Sensors
NOTE: Some systems store data in memory that is lost when the battery is disconnected. Before disconnecting the battery, refer to Battery Terminal
Disconnection and Reconnection See: Starting and Charging/Battery/Service and Repair/Procedures.
-
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode. Disconnect the negative cable from the battery,
then wait at least 3 minutes before starting installation or replacement of the SRS unit or disconnecting the connectors from the SRS unit.
-
Be careful not to bump or impact the SRS unit, the front impact sensors, the side impact sensors, or the rear safing sensor when the ignition switch
is in ON (II), press the engine start/stop button to select the ON mode, for at least 3 minutes after the ignition switch is turned to LOCK (0), or the
engine start/stop button is pressed to select the OFF mode.
-
During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit, the front impact
sensors, the side impact sensors, or the rear safing sensor. The airbags could accidentally deploy and cause damage or injury.
-
After a collision where the front airbags, the side airbags, the side curtain airbags, or the seat belt tensioners deploy, go to Component
Replacement/Inspection after Deployment See: Restraint Systems/Air Bag Systems/Service and Repair. After a collision where the airbags or the
side airbags do not deploy, inspect for any damage or any deformation on the SRS unit, the front impact sensors, the side impact sensors, and the
rear safing sensor. Also, do the front seat active head restraint inspection See: Body and Frame/Seats/Head Rest/Testing and Inspection. Replace
all damaged parts.