ZDX V6-3.7L (2010)
NOTE:
-
Do not insert the pin probes of the tester or a jumper wire at the terminal port or the SRS short canceller terminal port.
-
To prevent damage to the connector terminals, do not insert the test equipment probes, paper clips, or other substitutes as they can damage the
terminals. Damaged terminals cause a poor connection and an incorrect measurement.
Water Proof SRS Connectors
When diagnosis/troubleshooting is done at water proof connector (A), use the terminal test port above the terminal you need to check. Gently contact the
pin probe of the tester or jumper wire at the terminal test port from the terminal side.
NOTE:
-
Do not insert the pin probes of the tester or a jumper wire into the terminal port.
-
To prevent damage to the connector terminals, do not insert the test equipment probes, paper clips, or other substitutes as they can damage the
terminals. Damaged terminals can cause a poor connection and an incorrect measurement.
Lever-Locked Connector
The SRS unit connectors have a lever lock.
SRS Unit Connectors
Disconnecting
