ZDX V6-3.7L (2010)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
TPMS Initiator Replacement
NOTE: Make sure the initiator mounting bracket is not bent or twisted as this may affect its communication with the TPMS control unit and the tire
pressure sensor.
Front
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Raise and support the vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
3. Remove the front wheel.
4. Remove the front inner fender See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Front Inner Fender Replacement
.
5. Disconnect the initiator 3P connector (A).
6. Remove the initiator (B) from the inner side of the wheelwell.
7. Install the initiator in the reverse order of removal.
Rear
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Raise and support the vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
3. Remove the rear wheel.
4. Remove the rear inner fender cover See: Body and Frame/Fender/Rear Fender/Rear Fender Liner/Service and Repair.
5. Disconnect the initiator 3P connector (A).
