ZDX V6-3.7L (2010)
11. Remove the inlet line clamp bolt (C).
12. Remove the inlet line clamp bolt (A), and disconnect the power steering pressure switch connector (B).
13. Remove the pump outlet hose/inlet line (A) through the wheelwell opening on the passenger's side.
14. Install the pump outlet hose/inlet line in the reverse order of removal, and note these items:
-
Fill the system with power steering fluid, and bleed air from the system.
-
Do not get power steering fluid or grease on the auto-tensioner, the alternator, the A/C compressor, the drive belt, or the pulley faces. Clean off
any fluid or grease before installation.
-
Start the engine, allow it to idle, and turn the steering wheel from lock to lock several times to warm up the fluid. Check the gearbox for leaks
See: Steering and Suspension/Steering/Testing and Inspection/Component Tests and General Diagnostics/Hydraulic Power Steering Fluid
Leakage Inspection.