ZDX V6-3.7L (2010)
NOTE:
-
Be careful not to damage the line (D) or other parts. Do not use tools.
-
If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
-
Do not remove the retainer from the line; once removed, the retainer must be replaced with a new one.
5. Check the contact area (A) of the line (B) for dirt or damage.
-
If it is dirty, clean the connector, and dry it with the compressed air.
-
If it is damaged, replace the fuel filter or the fuel feed line.
6. To prevent damage and keep foreign matter out, cover the disconnected connector and line ends with plastic bags (A).
NOTE: The retainer cannot be reused once it has been removed from the line.
Replace the retainer when:
-
replacing the fuel rail.
-
replacing the fuel feed line.
-
replacing the fuel pump.
-
replacing the fuel filter.
-
replacing the EVAP canister.
-
replacing the EVAP purge line.
-
replacing the fuel fill pipe.
-
replacing the fuel tank.
-
it has been removed from the fuel line.
-
it is damaged.