ZDX V6-3.7L (2010)
Fuel Line Coupler: Service and Repair
Fuel Line/Quick-Connect Fitting Installation
Fuel Line/Quick-Connect Fitting Installation
NOTE: Before you work on the fuel lines and fittings, read the Fuel Line/Quick-Connect Fitting Precautions See: Service Precautions.
1. Check the contact area (A) of the line (B) for dirt or damage, and clean it if needed.
2. Insert a new retainer (A) into the connector (B) if the retainer is damaged, or after:
-
replacing the fuel rail.
-
replacing the fuel feed line.
-
replacing the fuel pump.
-
replacing the fuel filter.
-
replacing the EVAP canister.
-
replacing the EVAP purge line.
-
replacing the fuel fill pipe.
-
replacing the fuel tank.
-
removing the retainer from the fuel line.
NOTE: When you replace a retainer, use the same size and manufacturer as the original retainer See: Service Precautions.
3. Before connecting a new fuel tube/quick-connect fitting assembly (A), remove the old retainer (B) from the mating line.