ZDX V6-3.7L (2010)
Air Bag Control Module: Service and Repair
ODS Unit Replacement
ODS Unit Replacement
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
2. Remove the front passenger's seat See: Body and Frame/Seats/Service and Repair/Front Seat Removal/Installation.
3. Remove the front seat back panel See: Body and Frame/Seats/Seat Cover/Service and Repair/Front Seat-Back Cover Replacement.
4. Turn over the seat-back cover/pad as needed See: Body and Frame/Seats/Seat Cover/Service and Repair/Front Seat-Back Cover Replacement.
5. Remove the cover (A), then disconnect the ODS unit 18P connector (B) and OPDS sensor connectors (C) from the ODS unit (D).
6. Remove the two bolts (E), and the ODS unit.
Installation
1. Place the ODS unit (A) on the seat-back frame. Tighten the two bolts (B), and connect the ODS unit 18P connector (C) and OPDS sensor
connectors (D) to the ODS unit. Reinstall the cover (E).