ZDX V6-3.7L (2010)
Seat Belt: Service and Repair
Front Seat Belt Replacement
Front Seat Belt Replacement
Front Seat Belt
SRS components are located in this area. Review the SRS component locations See: Air Bag Systems/Locations and the precautions and procedures
See: Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
If replacing the front seat belts after deployment, refer to Component Replacement/Inspection After Deployment for a complete list of other parts
that must also be replaced See: Air Bag Systems/Service and Repair.
-
Put on gloves to protect your hands.
-
Take care not to tear or damage the seat covers.
-
Check the front seat belts for damage See: Testing and Inspection, and replace them if necessary.
-
The driver's seat is shown; the passenger's seat is similar.
1. Slide the front seat all the way forward and lower it all the way down. Carefully pry up on the bottom of the anchor cover (A) at the pry point (B)
with the appropriate trim tool to release the hooks (C) and the tab (D), then remove the cover by pulling it upward.
2. Remove the lower anchor bolt (A).
3. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before beginning work.
