ZDX V6-3.7L (2010)
Power Seat Switch: Service and Repair
Front Passenger's Power Seat Adjustment Switch Test/Replacement
Front Passenger's Power Seat Adjustment Switch Test/Replacement
Front Passenger's Seat
NOTE: SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations, precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair
before doing repairs or servicing.
1. Remove the front passenger's seat See: Body and Frame/Seats/Service and Repair/Front Seat Removal/Installation.
2. Remove the power seat adjustment switch knobs (A) and the recline cover from the front passenger's seat See: Body and Frame/Seats/Service and
Repair/Front Seat Recline Cover Removal/Installation, then remove the two screws and the power seat adjustment switch (B).
3. Disconnect the 12P connector from the power seat adjustment switch.
4. Reinstall the adjustment switch knobs to the switch.
5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity is not as specified, replace the switch.
