ZDX V6-3.7L (2010)
Power Seat Switch: Service and Repair
Power Lumbar Support Switch Test/Replacement
Power Lumbar Support Switch Test/Replacement
NOTE: SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations, precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair
before doing repairs or servicing.
1. Separate the lumbar support switch cover (A) from the switch (B).
2. Disconnect the 5P connector (C) from the switch.
3. Check for continuity between the terminals in each switch position according to the table.
4. If the continuity is not as specified, replace the switch.
