ZDX V6-3.7L (2010)
5. Disconnect the battery sensor 2P connector.
6. Disconnect the negative battery cable, and isolate it from the battery.
7. Remove the bolt securing the ground cable to the vehicle's body, then remove the negative battery cable assembly.
8. Attach the new negative battery cable assembly ground cable to the body. Torque its bolt to 6.9-11.8 Nm (5.0-8.7 lb-ft).
9. Attach the negative battery cable to the negative battery terminal. Torque its nut to 4.0-6.0 N.m (3.0-4.5 lb-ft).
10. Connect the battery sensor 2P connector.
11. Apply multipurpose grease to the battery terminals to prevent corrosion.
12. Disconnect the computer memory saver from the DLC.
13. Do the power tilt and telescopic steering wheel system memorization procedure:
^ On MDX, insert the retractable key into the ignition switch, then remove it. The steering wheel automatically moves fully in and up to let you know
the system has reset.
^ On ZDX, insert the retractable key into the ignition switch, then remove it. Or, on models with the keyless access system, set the power mode to
