ZDX V6-3.7L (2010)
Starter Motor: Removal and Replacement
Starter Removal and Installation
Removal
1. Do the battery removal procedure See: Battery/Service and Repair/Removal and Replacement.
2. Remove the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Removal.
3. Disconnect the positive starter cable (A) and the S terminal connector (B).
4. Remove the lower radiator hose bracket (C) from the starter and remove the dipstick (D).
5. Remove the two bolts holding the starter, then remove the starter.
Installation
1. Install the starter, then tighten the mounting bolts (A).
NOTE: Always use a new gasket.