ZDX V6-3.7L (2010)
Starter Solenoid: Testing and Inspection
Starter Solenoid Test
1. Do the battery removal procedure See: Battery/Service and Repair/Removal and Replacement.
2. Remove the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Removal.
3. Disconnect the positive starter cable (A), the motor wire (B), and the S terminal connector (C).
4. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
-
If there is continuity, go to step 5.
-
If there is no continuity, replace the solenoid.
5. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
-
If there is continuity, the solenoid is OK.
-
If there is no continuity, replace the solenoid.
6. Install the wire and the connector in the reverse order of removal.
7. Install the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Installation.
8. Do the battery installation procedure See: Battery/Service and Repair/Removal and Replacement.