ZDX V6-3.7L (2010)
16. Inspect the driveshaft by rotating the inner race slowly. If you feel any play (axial or radial), remove the worn driveshaft (C), and install a new
driveshaft (D).
Reassembly
17. Align the pin (A) of the subvalve (B) with the oil passage (C) in the pump housing, and push the subvalve into place, then install the snap ring (D).
18. Install the new pump seal (A) (with its grooved side facing in) into the pump housing (B) by hand first, then drive it in using the driver handle and
bearing driver attachment until there is no step at the top of the pump seal, and the seal is fully seated in the pump housing.
19. Position the driveshaft (A) in the pump housing, then press it in with the appropriate size socket (B) as shown.
