ZDX V6-3.7L (2010)
20. Install the 40 mm snap ring (C) with its beveled edge facing out.
21. Coat the new pump cover seal (A) with power steering fluid, and install it into the groove in the pump cover (B).
22. Install the outer side plate (C) over the two roll pins (D) with its arrow marks stamped (E) facing down.
23. Set the cam ring (A) over the two roll pins with the "dot" marks (B) facing down.
24. Install the rotor (A) to the pump cover (B).
25. Set the 10 vanes (C) into the grooves in the rotor. Make sure that the round ends (D) of the vanes are in contact with the sliding surface of the cam