ZDX V6-3.7L (2010)
Steering Wheel: Removal and Replacement
Steering Wheel Installation
Steering Wheel Installation
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations, and the precautions
and procedures See: Steering Column/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
1. Before installing the steering wheel, make sure the front wheels are pointing straight ahead, then center the cable reel (A). Do this by first rotating
the cable reel clockwise until it stops. Then rotate it counterclockwise about three full turns. The arrow mark (B) on the cable reel label should
point straight up.
2. Position the two tabs (A) of the turn signal canceling sleeve (B) as shown. Install the steering wheel on to the steering column shaft; making sure
the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the turn signal canceling sleeve. Do not tap on the steering wheel or
steering column shaft when installing the steering wheel.
3. Install the steering wheel bolt (A), and tighten it to the specified torque. Connect the cable reel subharness connector (B). Make sure the wire
harness is routed and fastened properly.