ZDX V6-3.7L (2010)
4. Install the driver's airbag See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Driver's Airbag
Replacement.
5. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, and check these items:
-
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; and check that the SRS indicator comes on for
about 6 seconds, and then goes off.
-
Make sure the horn and turn signal switches work properly.
-
Make sure the steering wheel switches work properly.
6. After installation, check these items:
-
Check the steering wheel spoke angle. If the steering spoke angles to the right and left are not equal (steering wheel is not centered), correct the
engagement of the wheel/column shaft splines.
-
Do the VSA sensor neutral position memorization See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Programming and Relearning/VSA Sensor Neutral Position Memorization.