ZDX V6-3.7L (2010)
Control Arm: Service and Repair
Front Lower Arm Removal/Installation
Front Lower Arm Removal/Installation
Special Tools Required
-
Ball Joint Thread Protector, 14 mm 071AF-SZNA100
-
Ball Joint Remover, 32 mm 07MAC-SL0A102
Removal/Installation
1. Raise and support the vehicle See: Wheels and Tires/Vehicle Lifting/Service and Repair.
2. Remove the front wheel.
3. With active damper system: Remove the suspension stroke sensor (A) from the lower arm (B), and detach the harness clip (C).
NOTE: Use the new nut during reassembly.
4. Remove the lock pin (A) from the lower arm ball joint, then remove the castle nut (B).
NOTE: During installation, install the lock pin as shown after tightening the new castle nut.