ZDX V6-3.7L (2010)
5. Disconnect the lower arm ball joint from the knuckle using the ball joint thread protector and the ball joint remover See: Ball Joint/Service and
Repair/Ball Joint Removal.
NOTE:
-
Be careful not to damage the ball joint boot when installing the remover.
-
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
6. Remove the mounting bolt (A) of the rear side on the stabilizer bar bushing holder.
NOTE: During installation, install the mounting bolt after tightening the lower arm mounting 14 mm bolts to the specified torque.
7. Remove the lower arm mounting 14 mm and 16 mm bolts, then remove the lower arm (B).
NOTE: Use the new mounting bolts during reassembly.