ZDX V6-3.7L (2010)
3. Position a floor jack under lower arm B. Raise the floor jack until the hole in lower arm B aligns with the hole in the damper, then loosely install
the new flange bolt (A) to the bottom of the damper.
4. Loosely install the new flange bolt (C) to the knuckle.
5. Connect the stabilizer link (A) to lower arm B, and install the new flange nut (C), and tighten the flange nut to the specified torque, while holding
the joint pin (D) with the hex wrench (E).
