ZDX V6-3.7L (2010)
NOTE:
-
When compressing the damper spring, use a commercially available strut spring compressor (Branick MST-580A or Model 7200, or equivalent)
according to the manufacturer's instructions.
-
Except where called out, the illustrations are shown without active damper system.
-
Refer to the Exploded View as needed during the following procedure.
Disassembly
1. Compress the damper spring, then remove the self-locking nut (A) while holding the damper shaft with a hex wrench (B). Do not compress the
damper spring more than necessary to remove the nut.