ZDX V6-3.7L (2010)
Strut Housing: Service and Repair
Front Wheelhouse/Damper Housing
Removal
Mass production body welding positions and numbers
Construction
NOTE:
-
This section explains the procedures after removal of all related parts. For the related parts' removal procedure.
-
The component replacement procedure described here refers to recyclable parts removed from damaged units. Therefore, this procedure differs
from that where off-the-shelf. repair parts are installed.
-
Remove the wheelhouse upper member, and replace the bulkhead side member and the front wheelhouse.
-
Check the damper housing position for damage.
-
If necessary, replace the damper housing and the wheelhouse extension as an assembly.
-
Peel back the inner lower pillar, shown in [DETAIL Z]; drill two welded points at the joints for the wheelhouse extension and the dashboard
upper.