ZDX V6-3.7L (2010)
Installation
1. Clamp the new damper housing, the front wheelhouse, the bulkhead side member, the front end outrigger, and the front bulkhead, and measure the
front compartment diagonally.
2. Check the body dimensions.
-
Engine compartment
-
Engine side mount position
-
Bulkhead side member position
-
Engine compartment and front floor, under view
-
Repair chart, top view
-
Repair chart, side view
3. Tack weld the new parts and the front bulkhead into position.
4. Temporarily install the front subframe, and check the front side frame position.
5. Temporarily install the front fender, the hood, and the door, then check for differences in level and clearance.
Check the external parts fitting positions. If necessary, check the headlight and the front bumper positions. Make sure the body lines flow
smoothly.
6. Do the main welding.
Weld the damper housing (A) and the wheelhouse lower gusset (B) to the front side frame (C).
