ZDX V6-3.7L (2010)
Shifter A/T: Removal and Replacement
A/T Gear Position Indicator Replacement
A/T Gear Position Indicator Replacement
NOTE: The A/T gear position indicator, the park pin switch, and the shift lock solenoid harness are not available separately. Replace the A/T gear
position indicator, the park pin switch, and the shift lock solenoid harness as a set.
1. Remove the shift lever assembly See: A/T Shift Lever Removal.
2. Remove the shift lock solenoid, and disconnect the shift lock solenoid connector See: Actuators and Solenoids - A/T/Shift Interlock
Solenoid/Service and Repair.
3. Remove the harness wire ties (A).
4. Remove the park pin switch (B), and replace the A/T gear position indicator/park pin switch/shift lock solenoid harness assembly (C).
5. Connect the shift lock solenoid connector, and install the shift lock solenoid in the shift lever See: Actuators and Solenoids - A/T/Shift Interlock
Solenoid/Service and Repair.
6. Route the harnesses as shown. Take the slack out of the harnesses, and secure the harnesses with the harness wire ties (A).