ZDX V6-3.7L (2010)
11. If the cable end is out of position on the mounting stud, remove the shift cable from the bracket, and reinstall the shift cable. Do not install the shift
cable end on the mounting stud while the shift cable is on the bracket. If the shift cable end rides on the bottom of the mounting stud, rotate the
stud and align the square fitting with the hole.
12. Install and tighten the nut (A) on the shift cable end.
13. Remove the 6.0 mm (0.236 in) pin (B) that was installed to hold the shift lever.
14. Install the center console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center Console
Removal/Installation.
15. Route the harnesses on the A/T shift panel (A), and install the A/T gear position indicator (B) in the A/T shift panel.