ZDX V6-3.7L (2010)
Replace the paddle shifter + (upshift switch) See: Service and Repair/Removal and Replacement/Paddle Shifter Replacement.
5. Remove the cable reel See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair.
6. Check for continuity between dashboard wire harness 20P connector terminal No. 2 and body ground.
Is there continuity?
YES -
Go to step 7.
NO -
Repair an open in the wire between dashboard wire harness 20P connector terminal No. 2 and body ground (G405), or repair poor body ground (G405).
7. Check for continuity between dashboard wire harness 20P connector terminal No. 15 and body ground.
Is there continuity?
YES -
Repair a short to body ground in wire between dashboard wire harness 20P connector terminal No. 15 and PCM connector terminal A36.
NO -
Go to step 8.
8. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
9. Measure the voltage between dashboard wire harness 20P connector terminals No. 2 and No. 15.